Effect of number of layers of the reinforcing material on the thickness and weight characteristics of carbon fiber parts produced by vacuum infusion
https://doi.org/10.35164/0554-2901-2021-1-2-62-64
Abstract
In this work, regularities have been established that relate the number of layers of reinforcing material in a preform with the thickness and density of carbon fiber parts obtained by vacuum infusion. It is shown that in PCMs consisting of a small number of layers, the thickness of the monolayer is noticeably higher and the density is lower than in multilayer composites.
About the Authors
V. V. Sokolov
Kronshtadt JSC
Russian Federation
Russian Federation
Moscow
P. Yu. Antipov
Kronshtadt JSC
Russian Federation
Russian Federation
Moscow
O. A. Golishev
Kronshtadt JSC
Russian Federation
Russian Federation
Moscow
S. V. Dolinsky
Kronshtadt JSC
Russian Federation
Russian Federation
Moscow
References
1. Особенности сборки деталей из композиционных материалов в конструкциях летательных аппаратов / Ю.А. Вашуков. – Самара: Изд-во Самар. гос. аэрокосм. ун-та, 2007. – 68 с.
2. Коган Д.И., Душин М.И., Борщёв А.В., Вешкин Е.А., Абрамов П.А. , Макрушин К.В. Свойства конструкционных углепластиков, изготовленных пропиткой под вакуумом // Известия Самарского научного центра Российской академии наук. – 2012. – т. 14. – №4(2). – С. 762–766.
3. Duan Yuexin, Tan Zhaoyuan, Zhao Yan, Sun Jing. Compression Responses of Preform in Vacuum Infusion Process // Chinese Journal of Aeronautics. – 2008. – №21. – Р. 370 377.
4. Zeshan Yousaf. Investigation of deformation behaviour of dry textiles under forming forces by computed tomography: doctor of philosophy. The University of Manchester, 2014.
5. F.D. Dungan, M.T. Senoguz, A.M. Sastry, D.A. Faillaci. Simulations and Experiments on Low-Pressure Permeation of Fabrics: Part I—3D Modeling of Unbalanced Fabric // Journal of Composite materials. - 2001. - Vol. 35. - №.14. - Р. 1250–1284.
6. Z. Yousaf1 & P. Potluri 1 & P. J. Withers. Infl uence of Tow Architecture on Compaction and Nesting in Textile Preforms // Appl Compos Mater. – 2017. - №24. – Р. 337–350.
Review
For citations:
Sokolov V.V., Antipov P.Yu., Golishev O.A., Dolinsky S.V. Effect of number of layers of the reinforcing material on the thickness and weight characteristics of carbon fiber parts produced by vacuum infusion. Plasticheskie massy. 2021;(1-2):62-64. (In Russ.) https://doi.org/10.35164/0554-2901-2021-1-2-62-64
Views:
658
Email this article 
