The effect of the addition of carbon nanoparticles and methods for combining them with an epoxy matrix on the properties of polymeric composite materials
https://doi.org/10.35164/0554-2901-2019-11-12-34-37
Abstract
The influence of the methods of introducing carbon nanoparticles into the epoxy binder and their amount on the complex of physicomechanical characteristics of unidirectional organic and carbon plastics was evaluated. An increase in the breaking load in microplastic made of carbon filaments up to 86% due to the introduction of nanoparticles is shown. An increase in the compressive strength of unidirectional carbon-fiber specimens modified with nanoparticles using a wave machine, up to 32% in comparison with unmodified, has been established.
About the Authors
V. P. Kasilov
Mechanical Engineering Research Institute of the Russian Academy of Sciences (IMASH RAN)
Russian Federation
Russian Federation
K. S. Pakhomov
JSC Central Scientifi c Research Institute of Special Engineering (JSC TsNIISM)
Russian Federation
Russian Federation
N. V. Pimenov
JSC Central Scientifi c Research Institute of Special Engineering (JSC TsNIISM)
Russian Federation
Russian Federation
References
1. Ганиев Р.Ф. Волновые машины и технологии (введение в волновую технологию). – М.: Научно-издательский центр «Регулярная и хаотическая динамика», 2008. – 192 с.
2. ГОСТ 11262-80 Пластмассы. Метод испытания на растяжение.
3. ГОСТ 4648-71 Пластмассы. Метод испытаний на статический изгиб.
4. ГОСТ 4651-82 Пластмассы. Метод испытания на сжатие.
Review
For citations:
Kasilov V.P., Pakhomov K.S., Pimenov N.V. The effect of the addition of carbon nanoparticles and methods for combining them with an epoxy matrix on the properties of polymeric composite materials. Plasticheskie massy. 2019;1(11-12):34-37. (In Russ.) https://doi.org/10.35164/0554-2901-2019-11-12-34-37
Views:
469
Email this article 
